Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
C
POWER SUPPLY
ALKALINE BATTERIES
Open the battery compartment cover (4) and
remove the alkaline battery box. Insert 4 x AA
alkaline batteries (take care of correct polarity!)
and insert the box into the battery case. Close
the battery compartment cover. In case the ON/
OFF LED starts flashing the batteries must be
exchanged or the rechargeable battery must be
charged.
RECHARGEABLE BATTERY (KIT)
Open the battery compartment cover (4) and
insert the rechargeable battery pack. Close the
battery compartment cover.
Take the rechargeable battery off the instru-
ment to charge it. Insert it again when the
battery is fully charged.
The ON/OFF LED shows the battery status:
if it is flashing the battery power is too weak.
Ladezustandsanzeige
Ladegerät
The charger shows the charging status of the
instrument as below:
Permanent red light indicates that the battery is
being charged.
Akkupack außerhalb des Gerätes laden
Permanent green light indicates that the battery
is fully charged.
In connection with a mobile phone adapter or a
powerbank the USB 3.0 cable supplied with the
kit can be used for continuous power supply.
The connection is made with the outer socket
on the reverse side of the laser.
The rechargeable battery will note be
charged over this connection!
16
Publicité
Table des Matières
