Testing The Battery - Stihl AR 2000 L Notice D'emploi

10 Testing the Battery

3
The length of the connecting cable can be adjus‐
ted by making a loop on the battery (3) or at one
side (4).
► Fit the connecting cable so that has no kinks
and is as short as possible without hindering
your work.
9.3 Fitting and Removing Harness
9.3.1 Fitting and Adjusting the Carrying Sys‐
tem
► Put the battery on your back.
► Close buckle (2) on the waist belt.
► Close buckle (1) on the chest strap.
0458-820-9921-B
4
1
2
► Tighten the straps until the waist belt fits
snugly on your hips and the back padding is
against your back.
► Thread the end of the waist belt through the
loops (3 and 4).
9.3.2 Removing the Carrying System
► Loosen the straps.
► Open the buckles on the chest strap and waist
belt.
► Take the battery off your back.
10 Testing the Battery
10.1 Checking LEDs and Beeps
► Press button on battery.
The LEDs glow green and a short beep
sounds. The state of charge is indicated.
► If the right-hand LED flashes green and there
are six long beeps: Charge the battery.
► If the LEDs do not glow or flash or there are
no beeps: Do not use the battery and contact
your STIHL dealer for assistance.
There is a malfunction in the battery.
English
3
4
25