Conrad 61 88 88 Notice D'emploi page 24

• Remove the attachment screws in the left
hole (ill. 3).
• Carefully take the two halves of the hous-
ing apart.
• There are two installation holes on the bot-
tom of the housing.
• Take the bottom housing half and hold it
on the designated mounting spot.
• Draw the mounting holes (e.g. with a pen-
cil) on the wall.
• Drill the installation holes.
• Attach the casing to the installation place
using suitable mounting material.
b) Connection
1) Connection for the operating voltage 230 V/
AC 50 Hz (connect the phase here; L)
2) Connection for the cooling function
3) Connection for the heating function
4) Connection for the operating voltage
230 V/AC 50 Hz (connect the phase
here; N)
Figure 3
Connections:
23