Metabo HPT NT 65MA4 Manuel D'instructions Et De Sécurité page 15

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

The Nailer is now ready to operate.
Removing the nails:
1 Depress the nail feeder (A) slightly and
slowly slide the nail feeder (B) forward.
2 Remove the nails from the Nailer.
1
NAILER OPERATION
Read section titled "SAFETY"(pages 4 – 8).
Operators and others
in work area MUST
wear safety glasses
with
which
ANSI
specifi cations.
Ordinary
do
adequate protection.
WARNING
Only person who have
read and understand
this MANUAL should
operate the Nailer.
000Book̲NT65MA4(S)̲US̲metabo.indb 15
000Book̲NT65MA4(S)̲US̲metabo.indb 15
2
Nail Feeder (A)
DANGER
side
shields
conforms
to
Z87.1
eyeglasses
not
provide
NEVER point tool at yourself or
others in work area.
Keep fi ngers AWAY from trigger
when not driving nails to avoid
accidental discharge.
Know and understand what trigger
system you are using.
Please
read
and
"METHODS OF OPERATION" found
below.
Inspect the Nailer before operating
to determine actuation system.
Before starting work, check the
nailing operation switching device.
This metabo HPT nailer includes a
nailing operation switching device.
Before starting work, make sure
that
the
switching
properly set.
If the switching device is not set
properly, the nailer will not operate
correctly.
Never place your hands or body
closer than 8 inches (200 mm) from
fi ring head when using.
Do not drive nails into other
nails; nails can ricochet and hurt
someone.
Do
not
actuate
Nailer
Nailer is placed fi rmly against the
workpiece.
When working close to an edge
of a workpiece or at steep angles,
or
driving
fasteners
workpiece use care to minimize
chipping, splitting or splintering,
or free fl ight, ricochet or piercing of
fasteners, which may cause injury.
Never drive nails from both sides of
a wall at the same time. Nails can
be driven into and through the wall
and hit a person on the opposite
side.
Never use Nailer which is defective
or operating abnormally.
Do not use Nailer as hammer.
Disconnect air hose from Nailer
when:
1) it is not in use;
2) leaving work area;
3) elevating, lowering or otherwise
moving it to another location;
English
understand
device
is
unless
into
thin
15
2018/02/07 14:38:36
2018/02/07 14:38:36

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Nt 65ma4s

Table des Matières