Napa 520-1007 Directives De Fonctionnement page 4

POSSIBLE PROBLEMS AND SOLUTIONS
SOLUTIONS
The release valve is not closed.
Turn the valve clockwise tightly.
Low on oil. Refill the jack to the correct level of oil.
Pump seals and back-up ring is defective. Clean oil passages, replace
seals and renew oil. (Must be serviced by qualified service center)
The hydraulic system is filled with air. Open the release valve,
pump handle rapidly (4) full strokes to purge air, close release valve.
Return spring is broken or linkages binding.
Replace spring if broken. Grease pivot shaft, oil all lift arm linkages.
Discharge ball is not sealing hydraulic system and oil may be dirty.
Manually flush hydraulic system by raising and lowering lift arm by
hand. Open the release valve, as required to raise and lower the lift
arm. Manually raise and lower lift arm.
REV. 04/28/05 4