Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
STUDER Innotec
HP-COMPACT
4.9
The Remote Control RCC-01
As an option, a Remote Control can
be connected to the HP-COMPACT.
All operating controls and displays
except from level adjustment are
available on the Remote Control.
The Remote Control is supplied with
a 20m long cable. It can as long as
40m. The Remote Control is suitable
for surface mounting on the wall or
on to a switch board. It is fixed with 4
screws. The HP-COMPACT can
also
be
programmed
with
the
Remote Control. The Programming
is
described
in
the
section
„Programming".
The output power and the charging
currents are displayed on the Remote Control.
In the Remote Control there is an additional Alarm Contact and a built-in Control
Input. These two functions are available through Tip-jack RJ11/4 for use. This
Auxiliary Contact is Front / Work Contact (max. 0.5A!), which is independent from the
Auxiliary Contact of the HP-
COMPACT. This contact is active
in case of an alarm of the HP-
COMPACT.
The Control Input is connected in
parallel to the ON/OFF- push
button. The HP-COMPACT can
be switched on or off through this
input with an impulse button or
an impulse contact.
Caution: No external voltage
should be connected to this
Input Control.
Order Number for Remote Control: RCC-01
Dimensions: H x B x T / 111.5 x 136.5 x 25mm
4.10 The Temperature sensor CT-35
Operating voltage of lead-acid batteries change depends on
the temperature. To correct the operating voltages according
to the actual temperatures, a temperature sensor can be
connected to the HP-COMPACT.
The compensation through the sensor is –3mV/°C/Cell.
Order Number: CT-35
Dimensions: H x B x T / 58 x 51.5 x 22mm
HP-COMPACT V5.7
22/80
Publicité
Table des Matières
