The Multifunctional Contact; The Remote Control Rcc-01 - Studer Innotec COMPACT C 1600-12 Manuel D'utilisation Et De Montage

STUDER Innotec
The Solar Charge Controller works automatically and is always in operation. As soon
as the energy is delivered from the Solar Charge Controller, LED 3 "SOLAR
CHARGE" is lit and the batteries are being charged. The Solar Charge Controller
works even when the Battery Charger is functioning. The way of working is the
principally the same as that of the Battery Charger. The function is described in the
section on Battery Charger. The programming and the adjustments are carried out in
accordance with the same conditions. Check with your battery supplier which
adjustments must be carried out for your battery.
4.9

The Multifunctional Contact

In the COMPACT there is a built-in programmable power relay. The potential-free
change-over contact (NO – NC) of this power relay is connected to the screw
terminal AUX CONTACT.
Maximum Contact load: 230Vac / 12Vdc / 24Vdc / 16A !
With the Push Button 21 „AUXILIARY CONTACT" the contact can be manually
switched on or off independently from programming and from the operating situation.
The LED 5 "Contact active" shows the status of the contact. The drawing up the
screw terminal "AUX CONTACT" is the inactive position mode, LED 5 "Contact
active" off.
The switching on and off of this contact can be freely programmed for every
operating situation of the COMPACT witch situation is indicated with a LED. There is
no limitation to its application and it is left to your wishes as to where and how you
would like to use it. The example and the setting of this contact are explained in
chapter 5.4.
In factory we program this for a dysfunction alarm. The contact is active when one of
these situations is detected:
 Over temperature (LED 10 lit)
 Overload (LED 11 lit)
 Over or less voltage of batteries (LED 12 lit or blinking)
 COMPACT is turned off manually or with a fault (LED 13 lit)
In case this function is not wished, it must be modified by programming according to
procedure in chap. 5.4.

4.10 The Remote Control RCC-01

As an option, a Remote Control
can be connected
COMPACT. All operating controls
and displays except from level
adjustment are available on the
Remote Control.
Control is supplied with a 20m long
cable. It can as long as 40m. The
Remote Control is sui-table for
surface mounting on the wall or on
to a switch board. It is fixed with 4
screws. The COMPACT can also
be programmed with the Remote
Control. The Programming
descry-bed in
„Programming".
> 36Vdc / 3A !
to the
The Remote
is
the section
COMPACT V6.6
COMPACT
22/83