Rockwell Automation Allen-Bradley MicroLogix 1000 Instructions D'installation page 5

Safety Considerations
This equipment is suitable for use in Class I, Division 2, Groups A, B, C, D or
non-hazardous locations only (when product or packing is marked).
ATTENTION –
Explosion Hazard:
Substitution of components may impair suitability for Class I,
!
Division 2.
Do not replace components or disconnect equipment unless
power has been switched off and the area is known to be
non-hazardous.
Do not connect or disconnect connectors while circuit is live
unless area is known to be non-hazardous.
This product must be installed in an enclosure. All cables
connected to the product must remain in the enclosure or be
protected by conduit or other means.
Use only the following communication cables in Class I, Division 2, Hazardous
Locations.
Environment Classification
Class I, Division 2, Hazardous
Environment Environment
Installation Instructions
MicroLogix 1000 Programmable
Controllers
Communication Cable
1761-CBL-PM02 Series C
1761-CBL-HM02 Series C
1761-CBL-AM00 Series C
1761-CBL-AP00 Series C
2707-NC8 Series B
2707-NC9 Series B
2707-NC10 Series B
2707-NC11 Series B
3