Venga VG RVC 3000 Mode D'emploi page 9

HOME CLEANING
Auto cleaning
• At the start of a cleaning cycle, The
robot will map out the zone.
• During the cleaning cycle, the robot
touches the edges of the room, as well
as chair legs and other furniture.
• The unit continues this process until it
has cleaned up the entire zone.
• If its battery gets low before finishing a
cycle, the robot automatically returns
to the charging dock.
• Once the robot finishes its cleaning
cycle, it also returns to the charging
dock to recharge.
FLOOR MOPPING CLEANING
The robot is equipped with a water tank
that enables the robot to mop floors.
1. Attach the cloth and fill the tank with
water.
2. Remove the dust bin.
3. Place back the water tank and start the
robot.
Tip : you can also use the mopping as a dry
polishing function.
When finished, empty the water tank, rinse it
with clean water and store it dry or it may
become cloggy and smelly. Check that the
4 water drainage holes are not blocked,
unblock them if necessary with a small
needle.
SPOT CLEANING
When you select spot cleaning, the robot
cleans a defined area by spiraling outward
about 3 feet(1 meter) in diameter and
inward.
When you use this mode, the robot boosts is
vacuum power to provide the best cleaning
possible.
To start place your robot on top of the spot
to clean and press (spot) on the remote
control.
9 VG RVC 3000