Venga VG RVC 3000 Mode D'emploi page 6

REMOTE CONTROL
Auto Cleaning
Cleaning direction
control
Time setup
Spot Cleaning
Single room cleaning
Install 2 AAA batteries before using the remote control for the first time. Make sure the
positive and negative ends are facing the correct polarity direction as marked in the
battery compartment. (see ‚+' and ‚-‚ markings)
LED light
Breathing orange
Solid green
Solid orange
Off
Flashing / Solid red + Beeping
QUICK START
Plug in the charging dock, and place the
remaining excess cable into the trunking
at the bottom of charging dock.
Note: If you don't put the excess cable into
the trunking, it may get tangled with the
robot while charging or cleaning.
A. Charging dock position
1. Place the charging dock on a hard,
level surface and against a wall.
VG RVC 3000
Status
Charging
Standby / Cleaning / Fully charged
Low power and returning to Charging
Dock
Robot is off.
An error has occured. Refer to the
Troubleshooting - Error Tone section in this
manual for solutions
6
Display screen
Return to charging
dock
Start/Stop
Schedule setup
Edge Cleaning
Max suction function