Maintenance / Disposal; Lubricating The Cutting Mechanism; Tip For Energy Saving; Disposal Of The Machine - Intimus 21 CP4 Instructions D'opération

GB
feed opening or serious harm could result.
5 . Place the slide switch back in the auto (I) position.
You are now ready to resume normal shredding.
5

Maintenance / Disposal

5 .1 Lubricating the cutting mecha-
nism
Cross-cut cutting mechanism should be oiled regular
after a certain operating time to maintain the cutting
performance.
This can be easily accomplished if you pour special
shredder oil (Order-No. see „Accessories", p. 10) as
shown on a sheet of paper and feed it through the in-
let guide to the cutting mechanism (Fig. 2).
Fig. 2 Lubricating the cutting mechanism

5 .2 Tip for energy saving

Please make sure that the shredder is switched off over
night (slide switch (Fig. 1/3) position off ).
Keep the shredder turned off or unplugged when not
in use for prolonged periods of time.

5 .3 Disposal of the machine

Always dispose of the machine at the end of its
service life in an environmentally responsible
way. Do not toss any part of the machine or its
packaging into the garbage.
10
Translation of the Original Operation Manual
Übersetzung der Originalbetriebsanleitung
6

Technical Data

intimus 21 CP4
Shred Type:
Shred Width:
Shredding Capacity:
Input:
Duty cycle:
Feed Opening:
Dimensions (WxDxH):
Noise level:
Weight:
7

Accessories

Designation
Oil bottle, 110 ml
NOTE!
When reordering accessories and to purchase
spare parts, please contact your intimus ser-
vice partner.
000179
Cross-Cut
4 x 39 mm
14 sheets (80g/m2)
220-240V, 50-60 Hz
8 min. ON / 40 min OFF
220 mm
350 x 270 x 470 mm
55 dB(A)
8 kg
Order-No .
94649 1 11/17
88035