Montipower BRISTLE BLASTER CORDLESS Mode D'emploi page 9

®
BRISTLE BLASTER CORDLESS
5. Initial Operation
Please ensure the correct battery is fitted onto the unit. Specific info is listed on
the label at the bottom of the tool.
Always install 18V and fully charged batteries.
5.1 Attaching the Vibration Damping handle
Always work with the Vibration Damping handle (4) attached! Attach the handle on
the top or bottom side of the machine, depending on working position, and secure.
See Figure 5.
Figure 5
5.2 Attaching the Protective Cap
Always work with the Protective Cap (7) attached.
Installing:
Slide the Protective Cap (7) over the cams on de front end as shown below and secure by
tightening the screw on the side. See Figure 6.
1
Figure 6
2
EN
3
9