Montipower BRISTLE BLASTER CORDLESS Mode D'emploi page 13

®
BRISTLE BLASTER CORDLESS
8. Cleaning
Motor cleaning: Holding the machine firmly,
slots of the machine regularly, Figure 2, frequently and thoroughly.
9. Troubleshooting
9.1 Battery powered machines:
• Overload protection: There is a MAJOR reduction in load speed.
temperature is too high! Allow the machine to run at idle speed until it has cooled down.
• Overload protection: There is a SLIGHT reduction in load speed.
overloaded. Reduce the load before continuing to work.
• S-automatic safety shutdown: The machine was SWITCHED OFF automatically.
If the slew rate of the current is too high (for example, if the machine suddenly seizes or
kickback occurs), the machine switches off. Release the dead man's switch to switch off
the machine. Switch it on again and continue to work as normal.
• Machine is running but Bristle Blaster
broken or heavily damaged and needs to be replaced. See Chapter 11, Repairs.
• Machine is running but no or limited roughness is created.
®
Bristle Blaster
needs to be replaced.
10. Accessories
Use only genuine MontiPower
Use only accessories which fulfil the requirements and specifications listed in these operating
instructions. For a complete range of accessories, see www.montipower.com.
11. Repairs
Repairs to electrical tools must be carried out by qualified electricians ONLY!
Contact your local MontiPower
requiring repairs.
You can download specific repair instructions and a list of spares and assemblies from
www.montipower.com.
12. Environmental Protection
The dust generated by the Bristle Blaster
do not dispose of with the household waste, but at a special collection point for
hazardous waste.
Observe national regulations on environmentally compatible disposal and on the recycling of
disused machines, packaging and accessories. Only for EU countries: Never dispose of power
tools and or its batteries in your household waste! In accordance with European Guideline
2012/19/EU on used electronic and electric equipment and its implementation in national legal
systems, used power tools must be collected separately and handed in for environmentally
compatible recycling.
Belt onto the object is incorrect, or the Bristle Blaster
®
accessories.
®
blow compressed air through the rear ventilation
®
Belt does not rotate.
representative if you have MontiPower
®
process may contain hazardous materials:
The motor
The machine is
The toothbelt is
The positioning of the
®
Belt is worn out and
®
power tools
EN
13