Montipower BRISTLE BLASTER CORDLESS Mode D'emploi page 5

®
BRISTLE BLASTER CORDLESS
3. General Safety Instructions
For your own protection and for the protection of your electrical tool, pay attention
to all parts of the text that are marked with this symbol!
WARNING
WARNING
warnings and instructions may result in electric shock, fire and/or serious injury.
Keep all safety instructions and information for future reference. Pass on your
electrical tool only together with these documents.
4. Special Safety Instructions
4.1 Safety Warnings Common for the use of Rotary Impact Tool Operations:
a) This power tool is intended to function as Rotary Impact Tool. Read all safety
warnings, instructions, illustrations and specifications provided with this power tool.
Failure to follow all instructions listed below may result in electric shock, fire and/or
serious injury.
b) No other operation than Rotary Impact Surface Preparation / Bristle Blasting shall be
performed with this power tool.
designed may create a hazard and cause personal injury.
c) Only use MontiPower Bristle Blaster
this tool. Do not use accessories which are not specifically designed and
recommended by the tool manufacturer.
attached to your power tool, it does not assure safe operation.
d) Do not use a damaged Bristle Blaster
before use.
e) After replacement of the Bristle Blaster
assembly.
f) After fitting accessories such as the Adaptor System and Bristle Blaster
remove Allen key / Torx wrench.
removed prior to switching on the tool.
g) On setting down the tool on a bench or on the floor, the label must always point
upward.
h) If the tool is not in use, disconnect from the power supply and store in a suitable, dry
place to prevent unintentional or unauthorised use in the absence of an authorised
individual.
i) In use, always hold by the tool body and the vertical handle.
j) Use Bristle Blaster
k) The Bristle Blaster
l) If the tool suddenly feels different (level of vibration) or produces a different noise
(pitch), the tool should be shut down immediately and the accessories such as the
Adaptor System, Bristle Blaster
m) Wear personal protective equipment. Depending on application, use face shield,
safety goggles or safety glasses. As appropriate, wear dust mask, hearing
protectors, gloves and workshop apron capable of stopping small abrasive or
workpiece fragments.
– Reading the operating instructions will reduce the risk of injury.
Read all safety warnings and instructions. Failure to follow all safety
®
Belt in the correct operating direction (Figure 3).
®
Belt can produce sparks on machining hard surfaces.
The eye protection must be capable of stopping flying debris
Operations for which the power tool was not
®
Belts and MontiPower
Just because the accessory can be
®
Belt or Adaptor System, inspect
®
Belt, check Adaptor System for correct
Always ensure the Allen key / Torx wrench is
®
Belt checked for damage.
®
Adaptor Systems with
®
Belt, always
EN
5