Operation; Starting The Generator Set - Carbest 92601 Manuel De L'utilisateur

GB
Check the air filter:
WARNING!
Never run the engine without the air filter. Rapid engine wear will result from contaminants, such
as dust and dirt being drawn through the carburetor, into the engine.
1. Loosen the cover screws, nuts and remove the maintenance cover. Remove the air filter cover and the air
filter sponge (Refer to Fig. 3.4).
2. Inspect the sponge for cleanliness.
3. Clean sponge with soap and water or solvent. Squeeze dry and then soak in clean engine oil. Squeeze out
all excess oil and reinstall.
4. Replace the sponge if it is damaged.
4.

OPERATION

4.1 Starting the generator set

NOTICE:
- A hot engine will not start if there is too much gasoline in the cylinder. If this happens, wait for 5 to
10 minutes for the engine to cool down before starting.
- The engine will stop automatically when it is out of gasoline.
54
Air filter sponge
Air filter cover
Fig. 3.4
Maintenance cover
Screws