Steinbach Active Balls+ Mode D'emploi page 10

Masquer les pouces Voir aussi pour Active Balls+:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
■ for pools up to 19,000 l capacity
■ Optional: Steinbach Container for Steinbach UV system
Operation with a pool vacuum cleaner (Illustration 9)
■ The pool vacuum cleaner's hose can be connected directly to the filter
system's suction pipe. In doing so, the pool vacuum cleaner's hose must
be completely filled with water.
■ The use of a skimmer with a strainer basket is recommended for filter
systems without pre-filters.
■ Please observe the pool vacuum cleaner's operating instructions. To
prevent the filter from running dry and thus overheating, no air should be
allowed to enter the filter system.
■ Please select the "FILTERN" position on the valve head.
■ Alternatively, you can also select the "ENTLEEREN (empty)" position,
for example if algae forms in the pool. Dirty pool water will not then run
back into the pool, but will be directly channelled away via the waste
pipe. When selecting this setting, it is necessary to re-fill your pool to the
correct level after cleaning, if necessary.
Trouble shooting
Cause of malfunctions
Pump sucks air (air bubbles on the
inlet side)
Skimmer or pump receives too little
water
Skimmer basket incorrectly installed
Pre-filter basket of the filter pump
incorrectly installed
In case of malfunctions not mentioned above, please contact your dealer!
Important information:
Wintering the filter system
■ Turn off the pump by unplugging the mains plug.
■ Close the shut-off valves or block the water flow to the connection hoses
of the pool.
■ Close the connecting pipes to the pool and empty the filter tank and the
hoses.
■ Set the valve lever to the "Winter" position to relieve the internal
components of the valve.
Change the Filter Balls
The
Filter
Balls
should
be
depending
on
how
much
Care instructions
Visible impurities are removed via the filter system. However, this does
not apply to algae, bacteria and other micro-organisms, which are also
a constant threat to clear, clean and healthy swimming pool water. For
their prevention or removal special water care products are available,
which when dosed correctly and regularly do not cause any irritation
for bathers and guarantee hygienically perfect water for swimming.
Cleaning
Turn the product off before cleaning and pull out the mains plug.
Use
conventional
cleaning
products.
or abrasive cleaning agents, i.e. no hard sponges, brushes etc..
Storage
The product must be thoroughly dried after cleaning. When the product is
not being used, store it in a well ventilated place out of direct sunlight. Avoid
direct sunlight. Make sure the room temperature is above 5°C in winter.
10
Rectification
Hoses defective, re-tighten the
hose clamps
Check water level and increase if
necessary, check suction pipe for
dirt
Clean the skimmer basket
Clean the pre-filter basket.
changed
every
2-3
years,
the
filter
system
is
operated.
Do
not
use
solvent
based
Disposal
Disposing of packaging: The packaging material has been selected in view
of environmental concerns and disposability and is therefore recyclable. The
paper and cardboard can be recycled, as can the plastic coverings.
Disposing of the product: Applicable in the European Union
and other European states with systems in place for collecting
and sorting recyclable materials. Dispose of the product in accor-
dance with any laws and regulations applicable at your place of
residence.
Old devices must not be placed in the household waste!
Should the robot become unusable, each customer is legally
obligated to separate old devices from the household waste,
e.g. take the device to your community/ area collection point. It is
therefore ensured that old devices are professionally recycled and
negative effects on the environments are mitigated. For this rea-
son, electrical devices are marked with the symbol depicted here.
Warranty conditions
The respective country's legal provisions for warranty conditions shall apply
accordingly.
Declaration of conformity (CE)
The EU declaration of conformity can be requested via the address shown at
the end of this manual..
040386_v1909
EN

Publicité

Table des Matières
loading

Table des Matières