Speck pumpen BADU Variostar Fiche Technique page 18

Notice: The speed cannot be changed during the
ventilation phase.
EN 18
Operation:
Press the button
preset fixed speed.
The pump is programmed according to the
factory settings, without ventilation time
As long as the pump is in the ventilation phase
a bar moves in the first position on the display
from the lower, through the middle to the
upper position.
During operation the pump is started up to the
fixed speed directly, without ventilation phase.
The motor is stopped by pressing the
button. The "Power" LED flashes and the
display shows "oFF".
If an analogue control is set in the parameters,
the motor can be restarted with the
Setting the speeds:
Press the button of the fixed speed that is to
be changed (
the speed by using the
speed is stored directly and approached
immediately when the fixed speed is selected
again.
Setting the parameters:
You can change to the setup menu by
pressing the button for 3 seconds. There
the button can be used to scroll through the
menu.
The first position of the display shows the
current menu item and the remaining four
positions show the parameter to be set.
If the button is pressed within the menu, all
the changed values are stored and the setup
menu exited. The text "StorE" is shown in the
display.
If you press the
exited without the changed values being
stored.
or to select the
or ) and then change
buttons. The set
button, the setup menu is
button.
09|2019