Tools Needed; Test The Wi-Fi® Signal Strength In Your Garage - Craftsman CMXEOCG232 Manuel Du Propriétaire

TOOLS NEEDED

During assembly, installation and adjustment of the opener, instructions will call for
hand tools as illustrated below.
Carpenter's Level
(optional)
Stepladder
Pencil
Wire Cutters
Screwdriver
Pliers
Tape Measure
Drill Bits 3/16",
Drill
5/16", and 5/32"
Sockets and Wrench 1/2",
5/8", 7/16", 9/16", and 1/4"
Hack Saw
Claw Hammer
Adjustable End Wrench
TEST THE WI-FI ® SIGNAL STRENGTH IN YOUR GARAGE
Monitor and control your garage door from anywhere using the myQ
need a router with Wi-Fi and a smartphone or other mobile device. Make sure your
mobile device is connected to your Wi-Fi network. Hold your mobile device in the
place where your garage door opener will be installed and check the Wi-Fi signal
strength.
Check Signal Strength. If you see:
Visit support.chamberlaingroup.com for more details
®
See myQ App Control page 32 to connect your garage door opener to your Wi-Fi
network. Do NOT connect prior to installation.
®
Wi-Fi is a registered trademark of Wi-Fi Alliance
4
®
App. You will
Wi-Fi signal is strong.
You're all set!
Install your new garage door opener.
Wi-Fi signal is weak.
The garage door opener will likely connect to
your Wi-Fi network. If not, try one of the
options below.
No Wi-Fi signal.
Try one of the following:
• Move your router closer to the garage door
opener to minimize interference from walls
and other objects
• Buy a Wi-Fi range extender