During assembly, installation and adjustment of the opener, instructions will call for hand tools shown below.
Carpenter's
Stepladder
WARNING
An unbalanced garage door might not reverse
when required and someone under the door
could be seriously injured or killed.
If your garage door binds, sticks or is out of
balance, call for professional garage door
service. Garage doors, door springs, cables,
pulleys, brackets and their hardware are under
CAUTION
extreme tension and can cause serious injury
or death. Do not try to loosen, move or adjust
them yourself!
Ropes left on a garage door could cause
someone to become entangled and killed.
Remove all ropes connected to the door before
installing and operating the opener.
Identify the type and height of your door and any
special conditions that exist and any additional
materials that may be required by referring to the lists
Escabeau
on page 4 or page 5.
You'll Need Tools
Level
Tape Measure
Drill
3/16", 5/16", and
5/32" Drill Bits
1/2" and 7/16" Sockets
and Wrench
Niveau de
menuisier
Perceuse
Clé à douille et douilles
de 1/2 po et 7/16 de po
SECTIONAL DOOR
Pencil
Wire Cutters
Pliers
Screwdriver
WARNING
To avoid damage to the garage door and
opener, disable locks before installing and
operating the opener. Use a wood screw or nail
to hold locks in the "open" (unlocked)
position.
Operation at other than 120V 60 Hz will cause
opener malfunction and damage.
WARNING
Crayon
Before you begin, complete the following test to
make sure your door is balanced, and is not
Ruban à mesurer
sticking or binding:
Pince coupante
• Lift the door about halfway as shown. Release the
door. It should stay in place, supported entirely by
its springs.
Forets de 3/16 de po,
de 5/16 de po et 5/32 de po
• Raise and lower the door to see if there is any
binding or sticking.
ONE-PIECE DOOR
3
Hack Saw
WARNING
Claw Hammer
Adjustable End Wrench
CAUTION
Scie à métaux
Marteau
Pince universelle
Clé à molette
Tournevis
SECTIONAL DOOR