Program The Travel - Craftsman CMXEOCG232 Manuel Du Propriétaire

ADJUSTMENT STEP 1

PROGRAM THE TRAVEL

1. Press and hold the Adjustment
Button until the UP Button
begins to flash and/or a beep is
heard.
2. Press and hold the UP Button
until the door is in the desired
UP position. NOTE: The UP and
DOWN Buttons can be used to
move the door up and down as
needed.
3. Once the door is in the desired
UP position press and release
the Adjustment Button. The
garage door opener lights will
flash twice and the DOWN
Button will begin to flash.
IMPORTANT NOTE: For one-
piece door installations refer to
page 29.
4. Press and hold the DOWN Button
until the door is in the desired
DOWN position. NOTE: The UP
and DOWN Buttons can be used
to move the door up and down
as needed.
5. Once the door is in the desired
DOWN position press and
release the Adjustment Button.
The garage door opener lights
will flash twice and the UP
Button will begin to flash.
Without a properly installed safety reversal system, persons (particularly small
children) could be SERIOUSLY INJURED or KILLED by a closing garage door.
• Incorrect adjustment of garage door travel limits will interfere with proper
operation of safety reversal system.
• After ANY adjustments are made, the safety reversal system MUST be tested.
Door MUST reverse on contact with 1-1/2" (3.8 cm) high object (or 2x4 laid
flat) on floor.
6. Press and release the UP
Button. When the door travels to
the programmed UP position,
the DOWN Button will begin to
flash.
7. Press and release the DOWN
Button. The door will travel to
the programmed DOWN position.
Programming is complete.
* If the garage door opener lights are flashing 5 times during the steps for Program
the Travel, the programming has timed out. If the garage door opener lights are
flashing 10 times during the steps for Program the Travel, the safety reversing
sensors are misaligned or obstructed (refer to page 28). When the sensors are aligned
and unobstructed, cycle the door through a complete up and down cycle using the
remote control or the UP and DOWN buttons. Programming is complete. If you are
unable to operate the door up and down, repeat the steps for Programming the Travel.
30