Using The Door Control - Model Cmxeocg472 - Craftsman CMXEOCG232 Manuel Du Propriétaire

USING THE DOOR CONTROL - MODEL CMXEOCG472

SYNCHRONIZE THE DOOR CONTROL
To synchronize the door control to the garage door opener, press the push bar until the
garage door opener activates (it may take up to 3 presses). Test the door control by
pressing the push bar, each press of the push bar will activate the garage door
opener.
USING THE DOOR CONTROL
Command LED
NOTE: If the command LED is
continuously blinking, the Lock
Push Bar
feature needs to be deactivated.
PUSH BAR
Press the push bar to open or close the door.
LOCK
The LOCK feature is designed to prevent activation of the garage door opener from
remote controls while still allowing activation from the door control and wireless
keypad. This feature is useful for added peace of mind when the home is empty (i.e.
vacation).
Activate: Press and hold the LOCK button for 2 seconds. The command LED will flash
as long as the lock feature is activated and your hand held remote control will not
operate your door at this time.
Deactivate: Press and hold the LOCK button again for 2 seconds. The command LED
will stop flashing and normal operation will resume.
LEARN
Button
LOCK
Button
LIGHT
Button
LEARN A DEVICE
Any compatible remote controls, wireless keypads, or myQ
programmed to the garage door opener by pressing the Learn button on the Dual-
Function Control Panel.
LIGHT
Press the LIGHT button to turn the garage door opener lights on or off. When the lights
are turned on they will stay on until the LIGHT button is pressed again, or until the
garage door opener is activated. Once the garage door opener is activated the lights
will turn off after the specified period of time (the factory setting is 4-1/2 minutes).
The LIGHT button will not control the lights when the door is in motion.
To change the amount of time the garage door opener lights will stay on:
Press and hold the LOCK button until the garage door opener lights flash.* The time
interval is indicated by the number of flashes.
NUMBER OF TIMES GARAGE DOOR OPENER
LIGHTS FLASH
1
2
3
4
To cycle through the time intervals repeat the step above.
LIGHT FEATURE
This feature will turn on the garage door opener lights when the safety reversing
sensors have been broken.
Deactivate:
Press and hold the LIGHT button until the garage door opener lights turn on, then off
again.*
Activate:
Start with the garage door opener lights on. Press and hold the LIGHT button until the
garage door opener lights turn off, then on again.*
* Approximately 10 seconds
35
®
accessories can be
TIME THE GARAGE DOOR OPENER LIGHT
STAYS ON
1 ½ Minutes
2 ½ Minutes
3 ½ Minutes
4 ½ Minutes