Unpacking & Assembly - Cleveland PS20W Guide Du Propriétaire

UNPACKING & ASSEMBLY
1. Remove heater from carton.
2. Remove all protective packaging applied to heater
for shipment.
3. Check heater for any shipping damage. If any
damage is found immediately contact the
manufacturer at 800-251-0001.
CAUTION: DAMAGED PARTS MAY
COMPROMISE SAFE OPERATION.
• DO NOT INSTALL INCOMPLETE COMPONENTS.
• DO NOT INSTALL SUBSTITUTE COMPONENTS.
• DO NOT INSTALL DAMAGED COMPONENTS.
4. Some components are packaged unattached from
the stove in order to ensure their safety during
shipping. Please find the protective packaging, likely
inside the stove door, to proceed with assembly.
Main Power Cord
The main power cord attaches to the stove at the
exposed socket in the rear of the stove. Once any
necessary assembly of the display panel screen is
complete you may briefly plug your stove in make
sure that it functions properly before proceeding with
installation. Unplug the stove once you confirm that
the display panel works.
CAUTION: DO NOT LEAVE THE STOVE
PLUGGED INTO ANY ELECTRICAL SUPPLY
DURING ASSEMBLY OR INSTALLATION.
Firepot
With the stove unplugged from any power supply, the
firepot should be inserted into the stove so that it is
securely positioned and also the hot surface igniter
should be able to make physical contact with pellets
that would be held in the firepot. See figure 2.
Figure 2: PS20W Firepot
A cleaning kit is also packaged which facilitates safely
cleaning the firepot perforations of debris.
Air Intake Kit
Locate the air intake kit packaged with the stove. See
Figure 4. Take measurements of your space and plan
for the installation of horizontal venting to the outside
Cleveland Iron Works Wood Pellet Fire Stove
41
as may be required per recommendations in "FRESH
AIR AND VENTILATION REQUIREMENTS 1" on page
7. Follow all ventilation requirements and guidelines
specified in "INSTALLATION" on page 7.
Termination Cap
Figure 3 Intake Kit
Additional Assembly
• The display panel: insert the display panel into the
top and rear of the stove. Be sure that the display
panel screen is facing towards the front of the stove.
Secure the screen using two of the provided screws.
• The power cord for the display panel: this cord
should be wrapped up near the top of the stove.
Insert free end into the back of the display panel
(see figure 16 on page 14). This wire should
already be connected to the stoves power board. This
connection can be checked behind the access plate at
the bottom and rear of stove .
Exhaust Duct Adapter
Locate the exhaust outlet pipe for your model of
stove. During assembly of the exhaust duct adapter
be sure to sandwich the sealing gasket between the
duct adapter and the stove. Use four of the provided
screws to complete the assembly. See Figure 4.
Figure 4: PS20W Exhaust Duct Adapter & Gasket
6
Operating Instructions and Owner's Manual
Hose Clamp
2" Flex Hose