Multi Function Controls - Cleveland PS20W Guide Du Propriétaire

Wireless Connection
Notification Light
MULTI FUNCTION DISPLAY
Power
Figure 16a Mounted Multi Function Controls Panel
Power
Manual /
Automatic
Toggle
Rate Select
Temperature
Decrease
Temperature
Increase
Figure 16b Remote Controller
Mounted Button Functionality: Normal Operation
• The light illuminates when the stove is
plugged into an electrical supply.
• Press the power button to turn the display
on for the purpose of adjusting settings.
The screen will become dim after 10
seconds on inactivity.
• Press and hold the power button for 3
seconds to begin stove heating if the stove
was off.
• Press and hold the power button for 3
seconds to begin stove shut off if the stove
was on.
CAUTION: The manufacturer has programmed
preset rates to ensure proper operation. It is not
advised to reprogram rate settings.
Cleveland Iron Works Wood Pellet Fire Stove

MULTI FUNCTION CONTROLS

Rate Select
Display Screen
Auto
16
Manual / Automatic
Notification Light
Settings
Time
Press to cycle between temperature reports
(in Fahrenheit) display in the top right of the
multi function display screen:
• ##(R): Room temperature
• ##(S): Exhaust temperature
• ##(P): Protection Temperature Sensor
Press to increase the temperature which
the stove is intended to heat the room to.
This value is displayed in the top right of the
multi function display screen as ##
Press to decrease the temperature which
the stove is intended to heat the room to.
This value is displayed in the top right of the
multi function display screen as ##
Press to toggle the stove between manual
control and programmed control. If the
stove is in the program controlled setting
then the notification light
illuminated.
Pressing the rate select will toggle between
four configurable heating presets. The
currently set preset is available in the top
middle of the multi function display screen
as P#.
• P1: Maximum Power
• P2: Medium Power
• P3: Low Power
• P4: Minimum Power
• Press and hold the settings button for 2
seconds to enter the set up menu.
• Press the settings button at any time to
exit the set up menu.
Operating Instructions and Owner's Manual
Confirm
Up Selector
Down Selector
0 F.
F.
0
will be