Smart Stove Wifi Connection - Cleveland PS20W Guide Du Propriétaire

MINIMIZING CREOSOTE FORMATION
See "MAINTENANCE" on page 17 for an explanation
of Creosote formation and removal. To slow the build
up of creosote within your chimney burn only the
recommended fuel, see page 12.
DISPOSAL OF ASHES
CAUTION: EMBERS MAY BE OBSCURED BY ASH.
HANDLE ASH WITH TOOLS SUFFICIENT FOR
FIRE TENDING, NEVER DIRECTLY WITH YOUR
HANDS. WEAR FIRE RETARDANT CLOTHING AND
PROTECTIVE EYEWARE.
Ashes should be placed in a metal container with a
tight fitting lid.
1. Other waste shall not be placed in ash containers.
2. The closed container of ashes should be placed
on a noncombustible floor or on the ground, well
away from all combustible materials, pending final
disposal.
3. Wood mineral residue (approximately 1-2%) remains
in the ash and is an excellent natural fertilizer
product for all garden plants. Before disposing ashes
of by burial in soil or otherwise locally dispersed,
they should be retained in the closed container until
all any and all cinders have thoroughly cooled and
should also be "quenched" with water.
Remote Button Functionality:
The buttons on the remote controller affect the stoves
operation in the same way that the mounted button
do, explained in v:
Remote Controller
Button
Auto
Note: There are no lights or display screen on the
remote controller that can indicate to you that the
button presses are being received by the stove. In
order to remotely control the stove but also monitor its
Cleveland Iron Works Wood Pellet Fire Stove
Mounted Button
Counterpart
settings, try installing the Smart Stove app.

SMART STOVE WIFI CONNECTION

This stove can be monitored, controlled, and
programmed by using the smart stove app by NHHATC
which is available for iOS or android device through the
app store.
Step 1. Download the Smart Stove app by NHHATC.
Step 2. Open the Smart Stove app. The app opens, by
default, to the "Devices" tab which is indicated
at the bottom of the screen.
Step 3. If you have no other wifi enabled devices
already added to this app there will be a large
button in the center of the screen which you
can select. Otherwise, select the + symbol in
the top right of the screen.
Step 4. Make sure that your device is connected to the
wifi network which you want the stove to be
connected to.
Step 5. Make sure that the wood pellet fire stove is
plugged into an electrical outlet and can be
powered on.
Step 6. Follow the directions on the screen by pressing
and holding the connection button for 3
seconds on the rear of the display panel
as illustrated in the figure below. Once you
observe the desired blinking pattern on the
indicator light, press the confirmation button at
the bottom of the screen.
LED
BUTTON
Figure 14 Display Panel Back
Step 7. Enter the password for the wifi network so that
the stove can connect to the wifi network.
Step 8. The stove will begin pairing with the device
running the application through the wifi
network. This process may take a few minutes.
Step 9. If the connection between the stove and device
fails, return to step 6. Rather than following
the directions currently on the screen, select
"AP Mode" in the top righthand corner. Then
proceed with steps 7 and 8.
Step 10. After the device and stove are paired, you
will be able to see the pellet stove as a
14
Operating Instructions and Owner's Manual
POWER
CORD