Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Read user's instructions before using this lighting unit.
Besides these instructions indicated on this page, you must respect the relevant safety and health
related requirements of the appropriate EU Directives.
This unit enters section 17: Lighting appliance for theatre stages, television, cinema and photograph
studios. Standards applied: EN 60598-1 and EN 60598-2-17.
This unit is considered as IP20, reserved for indoor use only.
LIGHTING UNIT.
•
Disconnect from the mains before any servicing. Warning, high voltage ignition.
•
The protection screens, lenses or U.V. filters must be replaced if there is any visual damage to a point
where their performances are reduced, for example, by cracks or deep scratches.
•
The lamp must be replaced if it has been damaged or deformed by the heat.
•
Do not use a bulb with a power or type which is different to that indicated.
•
Make sure the unit is correctly mounted on an appropriate support.
*
In a hanging position (hook, bolt...), the safety requirement of the unit must be assured by an other
hanging accessory (security cable, chain...) with a suitable length and correctly attached at the back of
the unit. This must be mounted as short as possible or rolled up a few times if needed.
*
Their movable accessories (barn doors, HMI shutters...) must also be safety assured with a
suitable security cable hooked onto the front of the unit. Take into account the weight, for a
correct attachment of the security cable.
•
Do not open the lighting unit, when the lamp is on.
•
U.V. rays: Protect your eyes.
•
Bulb and holder hot: wait until the unit is cold, before servicing.
•
Do not tamper with the security layout.
•
Tighten regularly the connections. Replace the cable with an identical one, if damaged.
•
Check the distance from any flammable material.
•
Do not expose to bad weather. Do not cover.
•
Use only with correct power supply.
•
Use only when lamp is in place.
•
If the lighting unit has any fans, make sure they are working correctly. If any are not working, turn the
unit off immediately and effectuate the necessary servicing.
•
Clean frequently the filters, if there are any.
•
Don't obstruct the air gaps.
•
Keep optical parts clean.
POWER SUPPLY.
•
Disconnect from the mains before any servicing
•
Mains connection only, do not connect to an «electronic output» (dimmer, static relay...).
•
Shelter from bad weather in an air ventilated area. Do not cover.
•
The power supply has circuit breakers, which should always be kept accessible.
•
There is no maximum distance between the lighting unit and the power supply. Even thou the distance
needs to be known, for the cable used.
•
Check the mains voltage.
•
These products have been built to conformity with European standards that concern professional lighting
equipment. Any modification made to our products, will cease the manufacturer's liability.
Professional material : Service only by qualified technician.
•
(
*
) Only for profile luminaires.
6
robert juliat
Route de Beaumont F 60530 Fresnoy-en-Thelle phone: 33 (0)3.44.26.51.89 - fax: 33 (0)3.44.26.90.79 - www.robertjuliat.fr
TECHNICAL FILE
USER'S INSTRUCTIONS
USER'S INSTRUCTIONS
1200W HMI FOLLOW SPOT
DISCHARGE LAMP LUMINAIRES
DISCHARGE LAMP LUMINAIRES
COLD RESTRIKE
VALID SINCE : 20.10.03
Thank you for your attention.
Publicité
Table des Matières
