Connecting The Control Wires - Renkforce DVD6311 Notice D'emploi

• The constant current +12 V pin (4) must be connected to a cable that supplies 12 V permanently even when the
ignition is off (terminal 30 of the on-board network). This terminal serves to save the user settings, time, etc.
• The aerial control output (5) supplies a voltage of +12 V when the device is switched on. This pin can be used
for the power supply of an electrical aerial or as switch-on voltage for an in-vehicle amplifier.
• The ignition +12 V pin (7) must be connected to a cable that is only live with +12 V when the ignition is on (terminal
15 of the on-board network).
Do not connect this pin to continuous current; otherwise the on-board battery could be discharged when the
vehicle is parked for a longer period of time.
• Connect the ground pin (8) to the vehicle body.

Adhesive techniques, which become increasingly common, or painted metal parts reduce electrical
conductivity. Therefore not every metal part is a suitable ground point.
In most vehicles, the cables for the electrical connection and for the connection to the loudspeakers
have been laid directly to the radio slot.
If this is not the case, make sure that any cables laid later are secured by the respective on-board fuses
(see vehicle operating instructions).

Connecting the control wires

• Connect the grey PARKING (+) wire to the handbrake switch. The contact connected to this pin must have ground
contact when the handbrake is pulled.

This makes sure the display (7) will only show films when the handbrake is pulled. This restriction only
applies to the built-in display. External displays intended for passengers are not affected.
This is a safety measure to avoid accidents due to a distracted driver. Please find out about the
applicable regulations for your country in this respect. It might be illegal to operate the device without
this connection.
In case it is not required, you can connect the gray PARKING (+) wire with the white PARKING (-) wire. Films will
then be displayed when driving.
• Connect the black TEL MUTE wire to the mute connection of your hands-free equipment. This will interrupt audio
playback during phone calls.
61