Installation Instructions; Ensuring The Door Seals Correctly - Bertazzoni REF24BMBPNB Manuel D'installation Et D'utilisation

4. INSTALLATION INSTRUCTIONS

4.1 Installation Instructions
CHANGING THE SIDE ON WHICH THE DOORS OPEN
1. Using a screw driver, remove the right upper
hinge cover and hinge.
2. Remove the upper door.
3. Remove the middle hinge and its connecting
pin underneath.
4. Remove the bottom door.
5. Remove the right bottom hinge and left plastic
plugs, and refit them on the opposite sides.
8
6. Mount the right upper hinge on the left bottom
corner and install the cover.
7. Remount the doors and hinges, working from
bottom to top (from 1-4).

4.2 Ensuring the door seals correctly

It is normal for the seal to be compressed after
the door has been reversed. With the door closed,
use a hair dryer to expand the seal and fill the gap
between the door and the body of the
appliance. Take care not to hold the hair dryer too
close to the appliance, which could damage the
seal.
A distance of approximately 4'' (10cm) should be
suitable. When completed, allow the seal and door
to cool before touching them. Once done, the seal
should remain in position.
The main consideration when installing any
refrigeration unit into a fitted kitchen is ventilation.
The heat removed from the cooling compartment
needs to be dissipated into the air around the
appliance. Incorrect ventilation can lead to
premature compressor failure, excessive power
consumption and total system failure and may
invalidate the warranty provided with the appliance.
For products intended to be installed inside a tall
housing cabinet, the following requirements must
be met: