Original Accessories/Auxiliary Equipment; Before Initial Use; Charging The Battery Pack (See Fig. A); Attaching/Disconnecting The Battery Pack To/From The Device - FLORABEST FAHE 20-Li A1 Traduction Des Instructions D'origine

as a plaything. Cleaning and user
maintenance tasks may not be car-
ried out by children unless they are
supervised.
This charger is suitable for
indoor use only.
If the supply cord is damaged, it
■
must be replaced by the manufac-
turer, its service agent or similarly
qualifi ed persons in order to avoid
a hazard.
RESIDUAL RISKS!
■ Even if you operate this power tool properly,
there will still be residual risks. The following
risks can occur in the context of the design
and construction of this power tool:
a) Cuts
b) Hearing damage, if no suitable hearing
protection is worn.
c) Damage to health caused by hand-
arm vibrations if the appliance is used for
extended periods or is not properly used and
maintained.
WARNING!
■ Do not operate the appliance with a dam-
aged cable, power cable or power plug. A
damaged power cable causes danger to life
by electric shock.
Original accessories/auxiliary
equipment
■ Use only the additional equipment and acces-
sories detailed in the operating instructions.
The use of tools and accessories other than
those recommended in the operating instruc-
tions could lead to an increased risk of personal
injury for you.
FAHE 20-Li A1

Before initial use

Charging the battery pack (see fig. A)
CAUTION!
► Always unplug the appliance before you re-
move the battery pack
battery pack to the high-speed charger
■ Never charge the battery pack
ambient temperature is below 10°C or above
40°C.
♦ Connect the battery pack
charger.
♦ Insert the power plug into the mains power
socket. The red control LED
♦ The green control LED
charging process is complete and the battery
pack is ready for use.
CAUTION!
♦ If the red control LED
that the battery pack
cannot be charged.
♦ If the red and green control LEDs
simultaneously, this means that the battery
pack is defective.
♦ Fit the battery pack
Attaching/disconnecting the battery
pack to/from the device
Attaching the battery pack:
♦ Allow the battery pack
handle of the appliance.
Removing the battery pack:
♦ Press the release button
battery pack .

Checking the battery charge level

♦ Press the battery charge level button
check the status of the battery. The status/
remaining charge will be shown on the battery
display LED as follows:
♦ RED/ORANGE/GREEN = maximum charge/
performance
RED/ORANGE = medium charge/performance
RED = low charge – charge the battery
from or connect the
.
when the
to the high-speed
will light up.
indicates that the
flashes, this means
has overheated and
flash
back onto the appliance.
to click onto the rear
and remove the
to
GB │ IE │ 29 ■