Saw Blade Selection; Saw Blade Change; Riving Knife/Splitter; Operation - Mafell KSS 400 Traduction De La Notice D'emploi Originale

4.5 Saw blade selection

Use a sharp tool to obtain a good cut quality and
select a tool from the following list according to
material and application:
For cuts along and across the grain in soft or
hard wood:
- TCT-circular saw blade Ø 160 x 1.6 x 20 mm (6
1/4 x 1/16 in. x 20 mm), 16 teeth
For cuts along and across the grain in soft or
hard wood:
- TCT circular saw blade Ø 160 x 1.8 x 20 mm ( 6
1/4 x 5/64 in. x 20 mm ), 24 teeth
For cuts especially along the grain in soft or hard
wood:
- TCT circular saw blade Ø 160 x 1.8 x 20 mm ( 6
1/4 x 5/64 in. x 20 mm ), 16 teeth
For cuts especially across the grain in soft or
hard wood:
- TCT circular saw blade Ø 160 x 1.8 x 20 mm ( 6
1/4 x 5/64 in. x 20 mm ), 32 teeth

4.6 Saw blade change

Danger
Unplug the rechargeable battery for
all service work.

Remove the
automatically blocks the shaft.

Using the Allen key 5 (bracket Fig. 1), unfasten
the flange screw 18 (Fig. 3) counter clockwise,
remove the screw and the front clamping flange
12.

Now you can remove the saw blade after
opening the retractable saw guard 13.

The clamping flanges must be free of adhering
parts.

Pay attention to the sense of rotation when
inserting the saw blade.

Afterwards, mount the clamping flange, attach
the flange screw and tighten it by clockwise
turning.

Refit the rechargeable battery.
rechargeable battery.

4.7 Riving knife/splitter

The riving knife / splitter 15 (Fig. 3) prevents the saw
blade from jamming during longitudinal cutting. The
correct distance to the saw blade is shown in (Fig. 4).

For adjustment, unfasten the two cylinder-head
screws 16 (Fig. 3) with the Allen-key supplied
with the saw 5 (Fig. 1).

Adjust the riving knife / splitter by shifting it in its
longitudinal slit. Afterwards retighten the two
cylinder-head screws.
5

Operation

5.1 Initial operation

Personnel entrusted to work with the machine must
be made aware of the operating instructions, calling
particular attention
instructions".
This

5.2 Switching on and off


Switching on: First press the lock-off button 1
(Fig. 1) and then press the switch trigger 2.

Switching off: To switch off, release the switch
trigger.

5.3 Cutting depth adjustment

The cutting depth is continuously variable between 0
and 49,5 mm (1 15/16 in.).
Proceed as follows:

Release the clamping lever 11 (Fig. 2).

Adjust the cutting depth using the plunge lever
6.

You can read the value off the scale at the
stationary guard. The bevelled edge of the lever
serves as indicator.
-22-
Do not pull out the rechargeable
battery while the machine is
running! The machine may get
damaged.
Danger
Unplug the rechargeable battery for
all service work.
to the chapter "Safety