Matrix Configuration; Passwords; Entering Program Mode; Menu Handling - Videotec SW164OSM Manuel D'instructions

5

Matrix configuration

The configuration of the SW164OSM is via on screen menu.
Warning ! Before starting configuration, ensure that a video signal is present on input 1 and a monitor is
connected to output 1.
5.1

Passwords

The SW164OSM matrix does not need any passwords, since these are defined locally in the KEYPLUS or
DCS2 control keyboards.
For further information, please refer to the keyboard user manual.
5.2

Entering Program mode

Warning ! Matrix configuration is only possible for the operator controlling output #1.
To enter the configuration menu follow this procedure:
• select output 1 by
• press
• if necessary, introduce the set up password
The menu list is displayed on screen.
5.3

Menu handling

Each menu is identified by a number: push the number to select the menu.
Enabled keys are usually indicated on screen.
The entry of a number from 1 to 16 is often required (for example for the selection of a parameter
displayed on screen).
To enter values lower than 10, press the corresponding key on the keypad.
For values from 10 to 16 press
number 13 press
The keys
screen), to move the cursor up, down, right and left.
To go back to the previous menu, press
m1
P
s
s
followed by
$ ( ) *
, , , are sometimes used as arrow keys (this function is always displayed on
(10 + ...) followed by the digit of the units : for example to enter
3
.
P
.
Page 19 SW164OSM 9901