Videotec SW164OSM Manuel D'instructions page 62

To change hour
From DATE/HOUR menu enter the HOUR PARAMETERS submenu by
2
pressing .
To change Hour and Minutes, select the relevant number (
U
its value by keys and
P
confirms the modifications and returns to the previous menu.
Date and Time position
From DATE/HOUR menu, enter the DATE/TIME POSITION submenu by
3
pressing .
Entering the menu, the actual positions of Date and Time are displayed.
1 2
By or it is possible to select which of the two positions has to be changed
(the activated position blinks), and by means of the arrow keys
is possible to change the position.
P
confirms the modifications and returns to the previous menu.
Day sequence start/end time
From DATE/TIME menu, press
Choose the time to be changed by pressing
the time is changed. The hour changes at 10-minute steps.
Warning ! If the night sequence cycle is not used, set the start time of the day
sequence at 00:00 and the end time at 23:59.
P
confirms the modifications and returns to the previous menu.
D
.
4
to access the DAY SEQUENCE submenu.
1
or
3 4
, ) and change
$ * ( )
, , ,
2 U
. By the keys and
Page 25
TIME PARAMETERS
------------------------
1. Show time: YES
3. Hour change: 12
4. Min. change: 15
------------------------
PROG.End
ß -DATE -
--TIME--
ß à
it
1:Date PROG.End
2:Time
DAY SEQUENCE
------------------------
D
1. Start time: >08:00<
2. End time :
Night seq.is active
from 17:00 to 07:59.
.increase time
á
â .decrease time
------------------------
PROG.End
6.2
à
á
ßâà
6.4
16:59
SW164OSM 9901