Installation; Notes On Safety For The Installation; Handling; Preliminary Checks - Riello RX 70 S/PV Instructions Pour Installation, Utilisation Et Entretien

5

Installation

5.1

Notes on safety for the installation

After carefully cleaning all around the area where the burner is to
be installed, and arranging for the environment to be illuminated
correctly, proceed with the installation operations.
All the installation, maintenance and disassembly
operations must be carried out with the electricity
supply disconnected.
DANGER
5.2

Handling

The burner packaging includes a wooden platform, it is therefore
possible to handle the burner (still packaged) with a pallet truck
or fork lift truck.
Burner handling operations can be highly
dangerous if not carried out with the greatest
attention: distance unauthorised personnel, check
integrity and suitability of the means available.
ATTENTION
Check also that the area in which you are working
is empty and that there is an adequate escape
area (i.e. a free, safe area to which you can
quickly move if the burner should fall).
During the handling, keep the load at not more
than 20-25cm from the ground.
5.3

Preliminary checks

Checking the consignment
After removing all the packaging, check the
integrity of the contents. In the event of doubt, do
not use the burner; contact the supplier.
CAUTION
The packaging elements (wooden cage or
cardboard box, nails, clips, plastic bags, etc.)
must not be abandoned as they are potential
sources of danger and pollution; they should be
collected and disposed of in the appropriate
places.
Checking the characteristics of the burner
Check the identification label of the burner (Fig. 4), showing:
 the model A) and type of burner B);
 the year of manufacture, in cryptographic form C);
 the serial number D);
 the electrical supply data E);
 the absorbed electrical power F);
 the types of fuel used and the relative supply pressures G);
 the possible minimum and maximum output data of the
burner H) (see Firing rate);
 maximum absorbed power I);
 burner weight L).
20144769
Installation
The installation of the burner must be carried out
by qualified personnel, as indicated in this manual
and in compliance with the standards and
regulations of the laws in force.
ATTENTION
The combustion air inside the boiler must be free
from hazardous mixes (e.g.: chloride, fluoride,
halogen); if present, it is highly recommended to
carry out cleaning and maintenance more
DANGER
frequently.
After positioning the burner near the installation
point, correctly dispose of all residual packaging,
separating the various types of material.
Before proceeding with the installation operations,
carefully clean all around the area where the
burner will be installed.
CAUTION
R.B.L.
D
GAS
GAZ
RIELLO S.p.A. / I-37045 Legnago(VR) cod. xxxxxxxx
The burner output must be within firing rate of the
boiler.
ATTENTION
A burner label that has been tampered with,
removed or is missing, along with anything else
that prevents the definite identification of the
burner makes any installation or maintenance
ATTENTION
work difficult
12 GB
A B
E
G H
G H
I L
S9753
C
F
....
Fig. 4