Publicité
Les langues disponibles
Les langues disponibles
It is essential to observe all the safety notes and tips!
Before completing and flying the model please read through the building instructions and the operating instructions for all
the components included in the set.
1. Check that the set contents are complete by referring to the Parts List.
2. Install the tailplane and fin
See paragraphs 2.12 and 2.13 of the building instructions and Figs. 18 - 21. Check that the servos are at neutral (centre)
when you fit the tail panels.
3. Assemble the model
See paragraph 5 of the building instructions and Fig. 33.
4. Bind the receiver to the transmitter
See the instructions supplied with the receiver and transmitter.
5. Set the correct control surface travels and Centre of Gravity
See paragraphs 7 and 8 of the building instructions and Fig. 34.
6. Go flying with the EasyGlider 4
See paragraphs 9 and 10 of the building instructions and Figs. 35 - 40.
Parts List RR+ EasyGlider 4
No.
Quantity
1
1
2
1
3
1
4
1
5
1
6
1
7
1
8
1
9
1
10
1
11
1
12
1
13
1
# 26 4332
BRIEF INSTRUCTIONS
The RR version of the EasyGlider 4 is factory-assembled, and virtually ready to fly. Numerous procedures which are described in the
building instructions are already completed for you, with the result that the model can be ready for the air in very short order. To fit out
the model completely you will also need a receiver and a flight battery.
Essential / recommended accessories:
Receiver
MULTIPLEX RX-5 light M-Link receiver
or MULTIPLEX RX-5 M-Link receiver (telemetry-capable)
Battery
LiPo battery, ROXXY EVO 3-2200 20C (M6)
Battery charger
Power Peak B6 12V / 230V charger
Tools required
Screwdriver for M5 slot-head screw
It is essential to observe all the safety notes and tips!
Before completing and flying the model please read through the building instructions and the operating instructions for all
the components included in the set.
1. Check that the set contents are complete by referring to the Parts List.
2. Install the tailplane and fin
See paragraphs 2.12 and 2.13 of the building instructions and Figs. 18 - 21. Check that the servos are at neutral (centre)
when you fit the tail panels.
18
Description
EasyGlider 4 building instructions
Complaint processing form
Fuselage with servos, power set and receiver
LiPo battery, ROXXY EVO 3-2200 20C (M6)
L.H. wing with servo
R.H. wing with servo
Tailplane
Fin
M5 plastic screw
Allen key, 1.5 mm A/F
Hook-and-loop tape, hook
Hook-and-loop tape, loop
Foam block battery retainer
Order No.
5 5808
Order No.
5 5817
Order No.
31 6655
Order No.
30 8561
Publicité
