Surtec Residencia 3 Guide De L'utilisateur page 23

2 Codes
The first code displayed is the administrator code. This code is programmed in the
factory (1111) and must be personalized when installing the central alarm unit.
and
Use the
To change a code, select the code, enter the new code on four digits then confirm by
pressing OK.
To delete a code, select the code, press OK then confirm by pressing OK again without
entering a code.
If you forget the administrator code, you cannot access the setup menu. The
intervention installer is required.
You cannot use the same code twice or two consecutive codes (e.g. 1111 and
1112). The alarm unit generates an error signal in this case.
3 Setting the Date and Time
This submenu is used for setting the alarm unit date and time:
Enter the day, month, year, hours and minutes in that order, then confirm by pressing OK
(key 6).
To check the settings, press OK then
4 Log
The event log contains all the events that occurred on the system. It is the memory of the
alarm unit.
The log contains the last 50 events and the date and time settings of the alarm unit.
An event record includes the date, time, access code used and event that occurred: alarm,
end of alarm, SOS, activations and deactivations of total and partial supervision, line power
failures, completed calls with the number of attempts made, numbers called, installer
actions, etc.
and
Use the
The symbol
5 Remote Parameter Setting
Before the system is placed in operation, the installer makes the parameter settings.
It may prove necessary later, depending on use of the alarm unit, to change the settings of
certain parameters such as the time delay on entry or exit.
These settings can be made from a distance by remote parameter setting.
The number of the remote parameter setting centre is programmed when the system is
installed. To make call, the administrator must confirm by pressing OK. The alarm unit
displays Unavailable if no number is programmed.
keys to run through the codes.
keys to run through the events.
goes out on entry in the Log submenu.
.
- 23 -