Activating Total Supervision - Surtec Residencia 3 Guide De L'utilisateur

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1

4. Activating Total Supervision

● On the alarm unit
Before activating supervision, check that the doors and windows are correctly closed.
Two procedures can be used to activate total supervision:
Procedure with entry of an access code:
Enter your access code then press Total supervision on (key 2).
If the alarm unit detects an error, an alert signal is generated and the reason for the
alert is displayed on the alarm unit.
If it is not possible to correct the error, you have 10 seconds to force operation by
pressing the Total supervision on key again. The error is ignored and supervision is
activated but the event is stored in the event log.
Procedure without code:
Hold Total supervision on (key 2) depressed for 2 seconds.
If the alarm unit detects an error, it ignores the error. Total supervision is activated but
the event is stored in the event log.
The time delay on exit is activated. The alarm unit broadcasts the message "
operation" and generates two beeps. During the time delay on exit, the alarm unit
generates a continuous audio signal and LED 1 flashes. You must exit from the premises
before the end of the time delay.
The alarm unit activates total supervision at the end of the time delay.
code
+
- 18 -

Total

Publicité

Table des Matières
loading

Table des Matières