Audio And Visual Signals - Surtec Residencia 3 Guide De L'utilisateur

3 Audio and Visual Signals

Indicators on Display
Lit: Line power on
Unlit: Line power failure
Lit: The alarm unit informs
you that an alarm is stored
and prompts you to view the
log
Audio Signals Generated by the Alarm Unit:
Alert
Alert signal generated when the alarm unit is turned on indicating that a detector is in
alarm status or faulty or that the battery is low or inoperative.
Time delay on
exit
Signal generated during the time delay on exit.
Time delay on
entry
Signal generated during the time delay on entry.
Accepted or
Confirmed
Signal output when a command is accepted or a detector is triggered in detector test
mode:
Error
Signal generated during a code entry error or when a command is refused.
Chime
Signal generated by passing in front of a detector programmed in chime mode.
Audio signals generated by the alarm unit and the siren (option
programmable on settings menu) when using a remote control: remote control
unit or keypad.
Total
supervision on
Signal generated when total supervision is activated.
Supervision off
Signal generated when the alarm unit is turned off.
♫
— ————
♫
———————
♫
— — — —
♫
——————
♫
— — — —
♫ ♫
♫
—— ——
♫
——————
Lit: Battery low
Unlit: Battery OK
Lit: The alarm unit is making a
call to call reception centre
- 17 -
1 short beep + 1 long beep
Time 0.2 sec + 0.6 sec
1 continuous long beep
1 beep every second
1 long beep
Time 1 second
4 rapid beeps
Ding dong
2 beeps
Time 2 x 0.3 seconds
1 long beep
Time 1 second