Activating Partial Supervision - Surtec Residencia 3 Guide De L'utilisateur

6 Activating Partial Supervision

● Activating partial supervision from the alarm unit
The system can be partially activated.
Before activating supervision, you must check that the doors and windows to be
supervised in partial mode are correctly closed.
Two procedures can be used to activate supervision:
Procedure with entry of an access code:
Partial supervision on (key 3).
If the alarm unit detects an error, an alert signal is generated and the reason for the
alert is displayed on the alarm unit.
If it is not possible to correct the error, you have 10 seconds to force operation by
pressing the Partial supervision on key (key 3) again. The error is ignored and
supervision is activated but the event is stored in the event log.
Procedure without code:
seconds.
If the alarm unit detects an error, it ignores the error. Supervision is activated but the
event is stored in the event log.
The time delay on exit is activated. The alarm unit broadcasts the message
"  Operation" and generates one beep. During the time delay on exit, the alarm unit
generates a continuous audio signal and LED 1 flashes. You must exit from the premises
before the end of the time delay.
The alarm unit activates partial supervision at the end of the time delay.
● Activating partial supervision from a remote keypad or remote
control unit
Partial supervision can be activated from a remote keypad or directly from a remote control
unit (key 3) using the same procedure.
If the alarm unit detects an error, partial supervision is inhibited.
You cannot force the activation of partial supervision from the keypad or the remote
control unit. Check the error displayed on the alarm unit.
code
+
Hold Partial supervision on (key 3) depressed for 2
- 20 -
Enter your access code then press