Ottobock 1E57 Lo Rider Instructions D'utilisation page 11

1 Product description
INFORMATION
Date of last update: 2020-07-07
► Please read this document carefully before using the product and
observe the safety notices.
► Instruct the user in the safe use of the product.
► Please contact the manufacturer if you have questions about the
product or in case of problems.
► Report each serious incident in connection with the product, in particu­
lar a worsening of the state of health, to the manufacturer and to the
relevant authority in your country.
► Please keep this document for your records.
1.1 Construction and Function
The 1E57 Lo Rider prosthetic foot is suitable for walking on various surfaces
and for a wide range of speeds.
The special combination of carbon and polyurethane absorbs heel strike.
The prosthetic foot permits perceptible plantar flexion at heel strike and a
natural rollover movement. Stored energy is released by the spring ele­
ments.
1.2 Combination possibilities
This prosthetic component is compatible with Ottobock's system of modular
connectors. Functionality with components of other manufacturers that have
compatible modular connectors has not been tested.
Limited combination options for Ottobock components
• High ankle moments occur on the prosthetic foot. Only use structural
components below the knee joint/prosthetic knee joint which are
approved for a higher body weight. (Example: body weight = 90 kg,
structural components approved up to 125 kg)
2 Intended use
2.1 Indications for use
The product is intended exclusively for lower limb exoprosthetic fittings.
2.2 Area of application
Our components perform optimally when paired with appropriate compon­
ents based upon weight and mobility grades identifiable by our MOBIS clas­
sification information and which have appropriate modular connectors.
English
11