Comet FDX BLADE XL 7.14 14/200D Notice Technique - Utilisation Et Entretien page 25

MAINTENANCE
SCHEDULE
Weekly
(FDX ENDURANCE)
Monthly
CAUTION
• When working, the high pressure cleaner should not be too noisy and there should be no obvious
drips of water or oil underneath it. If this is the case have the machine checked by a Specialized
Technician.
Special maintenance must only be done by a Specialized Technician, complying with the following table.
Also remember to carry out the special maintenance jobs listed in the engine operating and maintenance
manual.
MAINTENANCE
SCHEDULE
After the first 50 hours of
operation
Every 200 hours
Every 500 hours
CAUTION
• The data given in the table are approximate. It might be necessary to carry out maintenance more
frequently in the case of particularly heavy work.
• Clean the water inlet filter (23).
Turn the ring nut (62) anticlockwise until it is completely undone; take the filter
cartridge (63) out and clean it as explained above; in the case of truly stubborn dirt
change the cartridge, contacting a Specialized Technician for the right cartridge
to use; put the cartridge back in place and close the filter, turning the ring nut (62)
clockwise.
• Clean the water inlet filter (45) - (23) - (39) (refer to what has been explained
previously).
• Clean the detergent suction filter (40).
It is normally enough to put the filter under running water or blow it with
compressed air to clean it. In the most difficult cases use a scale remover or replace
it, contacting an authorised assistance centre to buy the new filter.
• Clean the nozzle.
It is normally enough to put the needle (29) supplied through the hole of the
nozzle to clean it. If the results are not good, replace the nozzle purchasing it from
an authorised assistance centre.
The professional fixed fan nozzle mounted on the nozzle holder heads (24) and
spray gun (19) can be replaced using a 14 mm box spanner (not supplied).
• Oil or grease the rotating or sliding parts the operator is able to reach (refer also to
the engine operating and maintenance manual).
• Check soundness of the water inlet and outlet circuits.
• Check tyre inflation pressure.
• Check clamping of the pump to the engine and the engine to the frame.
If clamping is found to be insecure do not, under any circumstances, use the
high pressure cleaner and contact a Specialized Technician.
SPECIAL MAINTENANCE
• Change pump oil.
• Check the pump's hydraulic circuit.
• Check pump and engine clamping.
• Change pump oil and gearbox oil.
• Check the pump suction/delivery valves.
• Check tightness of pump screws.
• Check the pump regulation valve.
• Check the safety devices.
JOB
JOB
EN
25