Battery Indicator - Petsafe ST-350-LD Manuel D'utilisation

Handheld Remote Digital Display
The Digital Display stays on for 1 minute after a button is pressed. After 1 minute with no
buttons pressed, the display shuts off and the Handheld Remote goes into battery conservation
mode. Pressing any button will cause the Digital Display to turn back on. The various display
symbols are explained below.
Numeric readout
Dog 1/ Dog 2
Tone or Static
Stimulation
Tone Only

Battery Indicator

Note: Factory preset is for Dog 1 mode, you will not see the Dog 2 symbol unless the unit is
programmed for Dog 2 (see 2-Dog System on page 17).
Battery Indicator
Battery is at
Handheld Remote is fully functional.
Battery is at
Remote will operate the Receiver
Collar, but should be recharged as
soon as possible.
Displays the Stimulation Level for Dog 1 or Dog 2.
The symbol displayed is the active dog Receiver
Collar. See 2-Dog System on page 17.
When pressing Tone or Stimulation Buttons, the
Dog 1 or Dog 2 symbol will appear in bold
or emphasised.
When pressing Tone Only for Dog 1 or Dog 2 the
number zero appears.
The Battery Indicator provides constant awareness
of your battery's power level. See Battery Indicator
for more detailed information.
⁄ to Full capacity.
2
3
⁄ capacity. Handheld
1
6
www.petsafe.net
Battery is at ⁄ capacity.
1
3
Handheld Remote is still fully
functional.
Battery is almost depleted.
Handheld Remote is unable to
operate the Receiver Collar.
11