Sirius SLT950 Instructions D'utilisation Et Avis De Montage page 15

the false ceiling.
It is possible to select the side of the cooker
hood where the air suctioned can be dischar-
ged, as follows:
Remove the eight fixing screws of the air-ou-
tlet flange shown in fig. 17, and place the
suctioning unit on the desired side where the
cover was previously removed.
Refit the cover on the unused air out-let
hole.
Carry out the installation following the pro-
cedure shown for SLT950 EM and SLT951
EM models.
WORKING
6 - channel radio control for cooker hood re-
mote (fig. 10).
Technical data:
Alkaline battery powered: 12v mod. 23A
Operating frequency: 433.92 Mhz
Combinations: 4096
Max. consumption: 25mA
Operating temperature: -20° : +55°C
- To light the cooker hood on or to
light it off press the button:
- To increase the speed up to the
fourth one press the button:
- To reduce the speed up to the
second one press the button:
- To go from a high speed back to
the first one press twice the button:
- To give power to the lights or to
shut them down press the button:
The "light" switch can turn the lights on and
off. after the first touch of the light switch
the lamps turn on at the maximum power.
SLT950 SLT951 SLT953: Keeping the switch
pressed the intensity of the light decreases
and then increases continuously. Leaving the
switch the brightness remains set up. Tou-
ching again the light switch it is possible to
turn the lamps off.
- To set the timer up press the
button:
At first ignition, keep pressed the lighting
button for 5 seconds
The LED on the right side will start to flash
(every 5 seconds), the hood will work for 10
minutes at the selected speed and then it li-
ghts automatically off.
15