Hama WLAN Router 300 Notice D'utilisation page 78

g
Setting the encryption for bridge point to point, bridge
point to multi-point and bridge WDS
Proceed as follows:
‹ On the home page, click the button "General Setup" and then
select "Wireless" in the menu on the left.
‹ Under the basic settings, select the mode "AP bridge point to
point", "AP bridge point to multi-point" or "AP bridge WDS".
‹ Then select "Security settings" in the menu on the left.
NOTE
►
►
The following encryption methods are available:
■ WEP encryption with 64 bit and 128 bit
■ WPA PSK (Pre-Shared Key) encryption
WEP (Wired Equivalent Privacy) encryption
78
Configuration and operation
For these operating modes you can carry out the setting of
the encryption at the end of the respective operating mode
settings by clicking the button "Security settings".
For WDS the encryption must be set beforehand in the
menu on the left under "Wireless/Security settings".
WLAN Router 300