Installation Location; Connection Of The Lan-Cables; Connection Of The Wan Cable - Hama WLAN Router 300 Notice D'utilisation

g
Demands on the installation location
For safe and trouble-free operation of the device, the installation loca-
tion has to satisfy the following requirements:
■ Install the device in a
possible obstacles between the device and the PCs.
■ Do not install the device in the vicinity of metallic objects and
other electrical or radiating devices.
NOTE
►
►
■ Do not expose the device to direct sunlight.
■ The mains socket must be easily accessible so that the mains
adapter can be quickly unplugged in the event of an emergency.

Connection of the LAN-cables

‹ Connect the computer and other network devices, such as hub/
switch, to the LAN jacks 1-4 using the network cable supplied.
The integral switch automatically detects the transmission rate of
10 or 100 Mbps, half/full duplex transmission mode and the cable
type used.

Connection of the WAN cable

‹ Connect the Ethernet port of your modem to the WAN port
the device using the cable supplied with your modem. If no cable
was supplied with the modem, use a commercially available
cable.
56
central location where there are the least
Try to eliminate the interference sources, such as DECT
telephones, mobile phones, bluetooth devices or other
WLAN networks.
If this is not possible, a change of channel can also remedy
the problem.
Installation
9 of
WLAN Router 300