Publicité
Les langues disponibles
Les langues disponibles
• Change all batteries if you notice the following
conditions:
– the operation range of the remote control
narrows
– the transmit indicator does not flash or is dim
• If the batteries run out, immediately remove
them from the remote control to prevent an
explosion or acid leak.
• If you find leaking batteries, discard the batteries
immediately, taking care not to touch the
leaked material. If the leaked material comes
into contact with your skin or gets into your
eyes or mouth, rinse it away immediately and
consult a doctor. Clean the battery compartment
thoroughly before installing new batteries.
• Do not use old batteries together with new ones.
This may shorten the life of the new batteries or
cause old batteries to leak.
• Do not use different types of batteries (such
as alkaline and manganese batteries) together.
Specification of batteries may be different even
though they look the same.
• Before inserting new batteries, wipe the
compartment clean.
• If the remote control is without batteries for more
than 2 minutes, or if exhausted batteries remain
in the remote control, the contents of the memory
may be cleared. In such a case, install new
batteries and set the remote control code.
• Dispose of batteries according to your regional
regulations.
• Keep batteries away from children. If a battery
is accidentally swallowed, contact your doctor
immediately.
• When not planning to use the remote control for
long periods of time, remove the batteries from
the remote control.
• Do not charge or disassemble the supplied
batteries.
• The batteries shall not be exposed to excessive
heat such as sunshine, fire or like.
A (Power key)
Turns on the power of this unit or sets it to the
standby mode.
The user shall not reverse engineer, decompile,
alter, translate or disassemble the software used
in this unit, whether in part or in whole. For
corporate users, employees of the corporation
itself as well as its business partners shall
observe the contractual bans stipulated within
this clause. If the stipulations of this clause and
this contract cannot be observed, the user shall
immediately discontinue using the software.
The name plate is located on the bottom of the
unit.
5
En
Information for Users on Collection and
Disposal of Old Equipment and Used
Batteries
These symbols on the products,
packaging, and/or accompanying
documents mean that used
electrical and electronic products
and batteries should not be mixed
with general household waste.
For proper treatment, recovery
and recycling of old products and
used batteries, please take them
to applicable collection points,
in accordance with your national
legislation and the Directives
2002/96/EC and 2006/66/EC.
By disposing of these products
and batteries correctly, you will
help to save valuable resources
and prevent any potential negative
effects on human health and
the environment which could
otherwise arise from inappropriate
waste handling.
For more information about
collection and recycling of old
products and batteries, please
contact your local municipality,
your waste disposal service or the
point of sale where you purchased
the items.
[Information on Disposal in
other Countries outside the
European Union]
These symbols are only valid in
the European Union. If you wish to
discard these items, please contact
your local authorities or dealer
and ask for the correct method of
disposal.
Note for the battery symbol
(bottom two symbol
examples):
This symbol might be used in
combination with a chemical
symbol. In this case it complies
with the requirement set by
the Directive for the chemical
involved.
Publicité
