Troubleshooting - Yamaha DVD-C950 Mode D'emploi

Troubleshooting

Troubleshooting
Refer to the chart below when this player does not function properly. If the
problem you are experiencing is not listed below or if the instruction below does
not help, set this player to the standby mode, disconnect the power cord, and
contact the nearest authorized YAMAHA dealer or service center.
Problem
No power
No picture
Distorted picture
Completely distorted picture
or black/white picture with
DVD
No sound or distorted sound
No audio at digital output
No output from subwoofer
during stereo
Disc can't be played
Picture freezes momentarily
during playback
This player does not respond to
the remote control
38
– Check if the AC power cord is properly connected.
– Press the STANDBY/ON on the front of the DVD system
to turn on the power.
– Refer to your TV's manual for correct Video In channel
selection. Change the TV channel until you see the DVD
screen.
– Check if the TV is switched on.
– Sometimes a small amount of picture distortion may appear
depending on the disc being played back. This is not a
malfunction.
– Make sure the disc is compatible with the DVD Player.
– Ensure that this player's TV Type is set to match that of the
disc and your TV.
– Adjust the volume.
– Check that the speakers are connected correctly.
– Check the digital connections.
– Check if your receiver can decode MPEG-2 or DTS and if
not, please make sure the digital output is set to PCM
ONLY.
– Check if the audio format of the selected audio language
matches your receiver capabilities.
– Check that all speaker settings in the setup menu have been
changed to small instead of large.
– The DVD+R/RW, DVD-R/RW, CD-R/RW must be
finalized.
– Ensure the disc label is facing up.
– Check if the disc is defective by trying another disc.
– If you have recorded a Picture CD or MP3 CD yourself,
ensure that your disc contains at least 10 pictures or 5 MP3
tracks.
– Region code incorrect.
– Check the disc for fingerprints/scratches and clean with a
soft cloth wiping from center to edge.
– Aim the remote control directly at the sensor on the front
of the player.
– Reduce the distance to the player.
– Replace the batteries in the remote control.
– Re-insert the batteries with their polarities (+/– signs) as
indicated.
Solution