Pads; Waves; Rhythm Wave View; Video - Reloop Touch Mode D'emploi

PADS

40. Displays the selected Pad Page (operation mode) for the Pads. Tap this area to get a scrolling menu and select a different Page. The selection can be made from the Touch unit, using
the [PAD MODE]+[PADS 1-8]
41. Displays the status (triggered or not) and the assigned value of each Pad, depending on the selected Pad Page. Tap a button to trigger the action assigned to the Pad (same as using [PAD
1-8] from the Touch unit)
42. Displays the value of the 1st Parameter of the selected Pad Page (if available). The 1st Parameter can be increased/decreased using the [PAD PARAM]+[PAD1/PAD2] buttons on the
Touch unit
43. Displays the value of the 2nd Parameter of the selected Pad Page (if available). The 2nd Parameter can be increased/decreased using the [PAD PARAM]+[PAD1/PAD2] buttons on the
Touch unit.
Read further about Pads and Pad Pages at the VirtualDJ Operation Manual http://www.virtualdj.com/manuals/virtualdj8/interface/decks/decksadvanced/pads.html

WAVES

The top section of the Touch Display will offer the Track's Waveform, regardless the selected Deck View (2 Decks – 4 Decks – Video). The Waveform can be shown as Scratch Wave or as
Rhythm Wave (selection from the Settings View)
The amount of the displayed Waveforms can be set to 2 (always show the Left and Right selected Decks), to 4 (show all 4 Decks) or automatically (will show the Left and Right Decks if a 2
Decks View is selected and all 4 Decks if the 4 Decks View is selected). This can be defined from the Settings View.
Scratch Wave View
Scratch Wave view – 2 Decks (Left/Right)
Scratch Wave view – 4 Decks
44. The Scratch Wave view offers the frequency structure of the track (Low, Mid and High frequencies are colored differently). Tap and slide to scratch and/or move the track in time, same
as if the [JOG] was used from the Touch unit.
The colors of the Waves indicate the frequency Band (Low, Mid and High) and depend on the selected Waves Color setting (from the Settings view). The Wave can be zoomed in/out from
the Settings view as well.

Rhythm Wave View

Rhythm Wave view – 2 Decks
Rhythm Wave view – 4 Decks
45. The Rhythm Wave view offers a structure of the track based mostly on the loudness of each frequency with focus on the Low ones. Tap and slide to scratch and/or move the track in time,
same as if the [JOG] was used from the Touch unit.
The color of the Wave matches the color of the Deck. The Wave can be zoomed in/out from the Settings view

VIDEO

46. Displays the Video Preview for the Left and Right selected decks. Tap this area to show the Deck Video Preview in Full screen and tap again to return to the Video view.
47. Displays the Master Video Output. Tap this area to show the Master Video Output in full screen and tap again to return to the Video view.
48. Displays the Video Crossfader position (can differ from the Audio Crossfader – controlled by the Touch unit)
49. Auto Video Crossfader mode. Tap this button to enable/disable the Auto V.CF mode. When enabled, the Video crossfader will automatically move from the very left position to a middle
position and end to the very right position, depending on the position of the Audio Crossfader and Volume faders of the Touch unit, providing a smart video mixing.
50. Link Video Crossfader mode. Tap this button to enable/disable the Link V.CF mode. When enabled, the Video Crossfader will follow the position of the Audio Crossfader.
10