Fisher & Paykel DCS Evolution BE Serie Guide D'installation page 16

Built-in Construction Details
Standard layout for cavity including insulated jacket
Note: vents are to be located at the left,
right and rear of the enclosure. Minimum
size of all vents is 10x10" (645mm x 645mm)
CAVITY DIMENSIONS
A Maximum height of enclosure shell
B Depth of enclosure shell
C Minimum depth for hood swing
D Width of enclosure cavity
E Height of enclosure cavity
f Depth to gas supply opening
G Height to base of vents
H Height of opening for access doors/drawers
I Width of opening for access doors/drawers
ACCESS DOORS
MODEL NUMBER
ADN1-20x48
ADN1-20x36
ADN1-20x30
ADN1-20x24
To order access drawers or doors, please visit www.dcsappliances.com for further details.
14
INSTALLATION
G
CAVITY WIDTH
ACCESS DRAWERS
MODEL NUMBER
ADR2-48
ADR2-36
ADR2-30
ADR2-24
D
F
E
I
H
FIG. 06
22 3/4" (578)
51 5/8" (1318)
CAVITY HEIGHT
Inches (mm) Inches (mm)
46" (1168) 20" (508)
34" (864) 20" (508)
28" (711) 20" (508)
22" (559) 20" (508)
Note: 4x4" (102mm x 102mm)
C
opening for gas supply line
B
A
Note: the cut-out of each
corner should be a 90°angle
in order for the access doors/
drawers to fit properly.
BE1-48R
Inches (mm)
35 1/2" (902)
3 3/4" (95)
11 1/8"(283)
18 1/2"(464)
1" (25)
20" (508)
46" (1168)
BE1-36R
Inches (mm)
35 1/2" (902)
22 3/4" (578)
3 3/4" (95)
40 1/2" (1029)
11 1/8"(283)
18 1/2"(464)
1" (25)
20" (508)
34" (864)