Télécharger Imprimer la page

Energetics PR-3000p Manuel D'assemblage page 10

Masquer les pouces Voir aussi pour PR-3000p:

Publicité

Les langues disponibles

Les langues disponibles

MAXIMUM ALLOWED RUNNING SURFACE LATERAL POSITION
On all ENERGETICS treadmills, the lateral side rails cover the walking belt for safety reasons. The space A between
the walking belt and the side rails should be evenly distributed on both sides and should not be more than 2 mm
on either side. If the space is larger than 2 mm, please follow the steps described in the "Belt adjustment paragraph",
provided in this manual.
Belt adjustment
Belt adjustment and tension performs two functions: adjustment for tension and centering. The running belt has been
adjusted properly at the factory. However transportation, uneven flooring or other unpredicted reasons could cause
the belt to shift off center resulting in the belt rubbing with the plastic side rail or end caps and possibly causing dam-
age. To adjust the belt back to it's proper position please follow the directions below:
Walking belt has shifted to the left: First unplug the power cord from the surge protector. Using the hex key pro-
vided, turn the left rear roller adjustment bolt 1/4 turn in the clockwise direction. Plug the power cord back into the
surge protector and run the treadmill at 4 km/h (2.5 mph). You should see the belt start to correct itself, moving back
towards the center. Repeat the above procedure until the walking belt is centered. It may be necessary to set walking
belt tension once you have completed this procedure if the belt feels like it is slipping while walking. Refer below to
the "Walking belt slipping" instructions.
Walking belt has shifted to the right: First unplug the power cord from the surge protector. Using the hex key pro-
vided, turn the right rear roller adjustment bolt 1/4 turn in the clockwise direction. Plug the power cord back into the
surge protector and run the treadmill at 4 km/h (2.5 mph). You should see the belt start to correct itself, moving back
towards the center. Repeat the above procedure until the walking belt is centered. It may be necessary to set walking
belt tension once you have completed this procedure if the belt feels like it is slipping while walking. Refer below to
the "Walking belt slipping" instructions.
10
www.energetics.eu
A
A

Publicité

loading