Publicité
Les langues disponibles
Les langues disponibles
Walking belt is slipping: First unplug the power cord from the surge protector. Using the hex key provided, turn
both the left and right rear roller adjustment bolts the same distance, usually a 1/4 turn in the clockwise direction.
Plug the power cord back into the surge protector and run the treadmill at 4 km/h (2.5 mph). You should now walk on
the belt to determine if the belt is still slipping. Repeat the above procedure until the walking belt is not slipping. The
tension should be just tight enough not to slip.
WARNING! Do not over tighten rollers! This will cause premature roller bearing failure!
Right and left tension bolts are located at the rear of the treadmill.
Assembly Information
1. Also refer to the drawings on the last pages of the manual.
2. Open the carton, put the main frame on the ground.
3. Fix the console cockpit on the uprights using designated screws (see assembly drawing for reference).
Important: Make sure you will not pinch, cut or damage the cable in any way (see hangtag). Please pay special
attention to the wire connecting of the upper board with the lower board. Please also make sure that you connect
the two cables correctly. The connection has been connected well once you hear a "click" sound. Any damage or
incorrect connection will cause major problems operating the machine.
Wire
Wire
EN
FR
11
Publicité
