Operating Other Equipment With The Cinemastation Remote Control; Storing Manufacturer Codes In The Remote Control; Setting The Manufacturer Code - Yamaha DVX-S200 Mode D'emploi

Operating Other Equipment with the CinemaStation Remote Control

Storing Manufacturer Codes in the Remote
Control

Setting the Manufacturer Code

POWER
/DTS
NIGHT
TV CH
PRESET
ON SCREEN
CH
STATUS
TV VOL
DVD/CD
MD/CD-R
MOVIE
84
If you set the manufacturer code (a unique code assigned to each
manufacturer) in the CinemaStation Remote Control, you can operate a
connected television, VCR, CD or MD recorder with the Remote Control.
Note
• Depending on the model, the Remote Control may not work, or only work with a limited
number of functions. In this case, use the remote control that came with the television, VCR,
CD or MD recorder.
DVR-S200 WB56620
POWER
TV
TV
AUDIO ANGLE SUBTITLE
Number
SELECT MATRIX 6.1 STEREO
REPEAT A-B
buttons
SW CENTER SURR
SHIFT
SHIFT
TV INPUT
A B C D E
SLEEP
PRESET
MENU
SET MENU
CH
ENTER
RETURN
TEST
VOLUME
MUTE
AMP
VIDEO 1
VCR
VCR
TUNER VIDEO 2
MD/CD-R
MUSIC SPORTS GAME
CINEMA
When a manufacturer code is set for the TV button, VCR
button or MD/CD-R button, you can begin using the
features described in "Available Operations" on page 85.
Note
• For the TV button you can only set a television manufacturer code and
for the VCR button or MD/CD-R button you can only set a VCR, CD
or MD recorder manufacturer code.
While holding down SHIFT, press TV, VCR or MD/
CD-R.
Each button can be assigned one manufacturer code.
Note
• Perform steps 1 to 2 while holding down SHIFT.
While holding down SHIFT, enter the
manufacturer code (3 digits) of the device with
the Number buttons.
For details, refer to "Manufacturer Code List" on
pages 87 and 88.
When the setting succeeds, "Code Set OK" appears;
however, when it does not, "Code Set NG" appears in the
CinemaStation Display. If setting is unsuccessful,
perform steps 1 and 2 again.
When finished entering the code, release your finger from
SHIFT.
Advice
• The TV button has 299, the VCR button has 399 and the MD/CD-R
button has 499 as the factory default setting for manufacturer code.
Make sure that you set the correct manufacturer
code.
With a manufacturer code set for the TV button, press the
button to turn the TV power on/off (standby), and check
that the setting is working correctly.
With a manufacturer code set for the VCR button or the
MD/CD-R button, press the button then the features
described in "Available Operations" on page 85, and
check that the setting is working correctly.